

- REPLACING DASHLIGHTS 2004 JEEP GRAND CHEROKEE LIMITED INSTALL
- REPLACING DASHLIGHTS 2004 JEEP GRAND CHEROKEE LIMITED DRIVERS
- REPLACING DASHLIGHTS 2004 JEEP GRAND CHEROKEE LIMITED MANUAL
(3) Install the HVAC unit into the vehicle (see part 2) (2) Plug in the wire harness connector to the blend door actuator. (1) Install the blend door actuator on the HVAC housing and tighten the two mounting screws to 2.2 N Install the lower I/P glove box door surround panel (see part 3)ĥ. Install the glove box door (see part 3)Ĥ. Plug in the wire harness connector to the blend door actuator.ģ. Install the blend door actuator on the HVAC housing and tighten the two mounting screws to 2.2 N
REPLACING DASHLIGHTS 2004 JEEP GRAND CHEROKEE LIMITED MANUAL
Installation – Manual system (single unit passenger/driver) & AZC (Driverside only)ġ. Remove the blend door actuator from the HVAC housing. Remove the 2 screws that secure the blend door actuator to the HVAC housing.Ħ. Unplug the wire harness connector from the blend door actuator (Fig. Remove the lower I/P glove box door surround panel (see Part 1).Ĥ. Disconnect and isolate the battery negative cable.Ģ. Removal – Manual system (single unit passenger/driver) and AZC system (driver side only)ġ. Remove the 2 screws that secure the blend door actuator to the HVAC housing.ĥ. This actuator is located on the front of the HVAC housing to the right of the floor panel transmission tunnel, and cannot be removed from the passenger compartment without instrument panel and HVAC housing removal.ģ.

The passenger side blend door actuator is used on all models equipped with Automatic Zone Control (AZC). Removal – AZC system (Passenger side only) FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. The passenger side, however, requires complete removal of the instrument panel and HVAC assembly.
REPLACING DASHLIGHTS 2004 JEEP GRAND CHEROKEE LIMITED DRIVERS
The AZC drivers side actuator can also be removed from the passemger compartment without removing the instrument panel. For Manual systems, the actuator is located on the front of the HVAC housing to the right of the floor panel transmission tunnel, and can be removed from the passenger compartment without instrument panel or HVAC housing removal. Part 2 – HVAC sub assembly removal and installationīack to main HVAC page Part 4 – Blend door actuator removal and installationĪ blend door actuator is used on all models, whether equipped with manual or Automatic Zone Control (AZC). Is something incorrect or missing? Please get in touch with us and we’ll fix it! We have organized as much information as we could find into a helpful article below. Welcome to the in-depth page on WJ Generation Jeep Grand Cherokee HVAC sub assembly replacement guide.
